IBM InfoWindow II 3153 - User Settings

24
User Settings
Use the chart below to document your system and terminal settings:
Parameters Examples: Your Settings:
Connections made
Number of sessions
Host/Printer (Session 1)*
Host/Printer (Session 2)*
Emulations (Session 1)
Emulations (Session 2)
C, D, and H
2
EIA/Para
Aux/None
IBM 3151
ADDS VP
Host 1:
Baud
Data Bits
Stop Bits
Parity
Parity Check
Flow Control (In)**
Flow Control (Out)***
Modem Control
9600
8
1
None
Off
Xon-Xoff
Xon-Xoff
On
(Dual Host mode only)
Host 2:
Baud
Data Bits
Stop Bits
Parity
Parity Check
Flow Control (In)**
Flow Control (Out)***
Modem Control
19200
7
2
Odd
On
DTR (or DSR)
DTR (or DSR)
Off
* In most cases, these parameters should not be the same.
** Incoming flow control on the host should correspond to
“EIA (or Aux) Rcv.”
*** Outgoing flow control on the host should correspond to
“EIA (or Aux) Xmt.”