31
Enhanced: [On, Off]
Normally, the terminal responds to a set of commands that correspond to the
emulation selected. When Enhanced mode is on, the set of commands is
extended to those printed in boldface in the Programming chapter.
EIA Data Format: [7/1/N, 7/1/O, 7/1/E, 7/1/M, 7/1/S, 7/2/N, 7/2/O, 7/2/E, 7/2/M, 7/2/S, 8/1/N, 8/1/O,
8/1/E, 8/1/M, 8/1/S, 8/2/N, 8/2/O, 8/2/E, 8/2/M, 8/2/S]
Select a data bits/stop bits/parity combination which matches the data
format of the primary host or printer. Parity abbreviations are: O = odd, E =
even, S = space, M = mark, and N = none.
AUX Data Format: [7/1/O, 7/1/E, 7/1/M, 7/1/S, 7/2/N, 7/2/O, 7/2/E, 7/2/M, 7/2/S, 8/1/N, 8/1/O, 8/1/E,
8/1/M, 8/1/S, 8/2/N]
Select a data bits/parity bits/stop combination which matches the data
format of the secondary host or printer. Parity abbreviations are: O = odd, E
= even, S = space, M = mark, and N = none.
Language: [U.S., U.K., Danish, Finnish, French, German, Norwegian, Portuguese, Spanish, Brazilian,
Swedish, Dutch, Belgian-Flemish, Fr-Canadian, Italian, Latin American, Swiss-French, Swiss-German,
Turkish, Greek, Hungarian, Czech, Slovak, Polish, Rumanian, Slovenian, Croatian, Bosnian, Serbian
Latin, Russian, Hebrew]
Select the language type which matches your keyboard’s layout.
Sessions: [One, Two]
Select the number of sessions that the terminal will run. One session is
required per connection to a host. When two sessions are selected, the
Setup menu will display the message “Press Ctrl-Enter (Kpd) to Toggle Sessions”
at the bottom of the screen. The current session is displayed at the upper
left corner of the status line (either by a SES1 or SES2 indicator). To change
the active session, press Ctrl and Enter (on the numeric keypad)
simultaneously.
Host/Printer: [EIA/Aux, EIA/Para, EIA/None, Aux/EIA, Aux/Para, Aux/None, None/EIA, None/Aux,
None/Para, None/None]
The first part of the selection indicates the host (either the EIA port or the
AUX port) and the second part of the selection indicates the printer port (if a
serial printer is used, either the EIA or Aux port can be used to connect to
the printer, but if a parallel printer is being used, the PAR port should be
used.) The active session “drives” the printer. EIA/Para is the default for
session 1, and Aux/None is the default for session 2.
To Next Page
Loading...
Need help?
General
