Failing function codes 151 through 2E33
Failing function codes (FFCs) identify a function within the system unit that is failing.
Table 29 describes the component that each function code identifies.
Note: When replacing a component, perform system verification for the component. See “Using the
diagnostics program” on page 189.
Table 29. Failing function codes 151 through 2E33
FFC Description and notes
151
1. Battery
Note: After replacing the battery:
a. Set the time and date.
b. Set the Network IP addresses (for blade servers that start up from a network).
2. System-board and chassis assembly
152 System-board and chassis assembly
166 Check management-module event log for a BladeCenter blower or fan fault. See the
documentation that comes with the BladeCenter unit.
210 System-board and chassis assembly
212 System-board and chassis assembly (cache problem)
214 System-board and chassis assembly
217 System-board and chassis assembly
219 Common Memory Logic problem for memory DIMMs.
Note: If more than one pair of memory DIMMs are reported missing:
1. Replace the memory DIMM at the physical location code that is reported
2. Replace the system-board
221 System-board and chassis assembly
226 System-board and chassis assembly
227 System-board and chassis assembly
241 Ethernet network problem
282 System-board and chassis assembly
292 System-board and chassis assembly (Host – PCI bridge problem)
293 System-board and chassis assembly (PCI – PCI bridge problem)
294 System-board and chassis assembly (MPIC interrupt controller problem)
296 PCI device or adapter problem.
Note: The replacement part can only be identified by the location code reported by diagnostics.
2C4 System-board and chassis assembly
2C6 2 GB DIMM 4 GB DIMM 8 GB DIMM
2C7 System-board and chassis assembly (Memory controller)
2C8 System-board and chassis assembly
2C9 System-board and chassis assembly
2D2 System-board and chassis assembly (Bus arbiter problem)
2D3 System-board and chassis assembly
2D4 System-board and chassis assembly (System/SP interface logic problem)
2D5 System-board and chassis assembly (I2C primary)
2D6 System-board and chassis assembly (I2C secondary)
Chapter 2. Diagnostics 181
To Next Page
Loading...
