EasyManuals Logo

IBM Power PS700 Problem Determination And Service Guide

IBM Power PS700
294 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #56 background imageLoading...
Page #56 background image
Table 15. B700xxxx Licensed internal code SRCs (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved. If an action solves the problem, then you can stop performing the remaining actions.
v See Chapter 3, “Parts listing, Type 8406,” on page 229 to determine which components are CRUs and which
components are FRUs.
B700 xxxx Error Codes Description Action
5302 An unsupported Preferred Operating
System was detected.
The Preferred Operating System
specified is not supported. The IPL will
not continue.
Work with IBM support to select a supported
Preferred Operating System; then, re-IPL the
system.
5303 An unsupported Preferred Operating
System was detected.
The Preferred Operating System
specified is not supported. The IPL will
continue.
Work with IBM support to select a supported
Preferred Operating System; then, re-IPL the
system.
5304 The number of available World Wide
Port Names (WWPN) is low.
https://www-912.ibm.com/supporthome.nsf/
document/51455410
5305 The number of available World Wide
Port Names (WWPN) is low.
https://www-912.ibm.com/supporthome.nsf/
document/51455410
5400 System firmware detected a problem
with a processor.
Replace the system-board and chassis
assembly, as described in “Replacing the FRU
system-board and chassis assembly” on page
260.
5442 System firmware detected an error. Replace the system-board and chassis
assembly, as described in “Replacing the FRU
system-board and chassis assembly” on page
260.
54DD Informational system log entry only. No corrective action is required.
5600 Informational system log entry only. No corrective action is required.
5601 System firmware failure. There was a
problem initializing, reading, or using
system location codes.
Go to “Isolating firmware problems” on page
218.
5602 The system has out-of-date VPD LIDs. Check for server firmware updates; then,
install the updates if available.
5603 Enclosure feature code and/or serial
number not valid.
Verify that the machine type, model, and serial
number are correct for this server.
6900 PCI host bridge failure
1. Replace the system-board, as described in
“Replacing the FRU system-board and
chassis assembly” on page 260.
2. If the problem persists, use the “PCI
expansion card (PIOCARD) problem
isolation procedure” on page 194 to
determine the failing component.
6906 System bus error Replace the system-board and chassis
assembly, as described in “Replacing the FRU
system-board and chassis assembly” on page
260.
44 Power Systems: Problem Determination and Service Guide for the IBM Power PS700 (8406-70Y)

Table of Contents

Other manuals for IBM Power PS700

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM Power PS700 and is the answer not in the manual?

IBM Power PS700 Specifications

General IconGeneral
BrandIBM
ModelPower PS700
CategoryServer
LanguageEnglish

Related product manuals