3. Use the handle to pull the fan module out of the expansion enclosure chassis,
as shown in Figure 104.
4. Repeat steps 2 on page 109 and 3 for each additional fan module you need to
remove.
Replace a fan module
5. To reinstall a fan module, or replace it with one from FRU stock, follow the
procedure in “Installing or replacing a fan module: 2076-92F” on page 85.
Removing a fan interface board: 2076-92F
You can remove a fan interface board (FIB) from a 2076-92F expansion enclosure.
Figure 103. Fan module release tab
Figure 104. Remove fan module
110 Storwize V7000 Gen2 and Gen2+: Quick Installation Guide
To Next Page
Loading...
