Table 22. Default user name and password for the initialization GUI
User name Password
superuser passw0rd
Note: The 0 character in the password is the number zero, not the letter “O”.
Initializing the system by using the technician port
To initialize a new system, you must connect a personal computer to the technician
port on the rear of a node canister and run the initialization tool.
Before you begin
You require the following items:
v A supported browser that is installed on the personal computer
v An Ethernet cable to connect the personal computer to the technician port
Attention: Do not connect the technician port to a switch. If a switch is detected,
the technician port connection might shut down, causing a 746 node error.
Procedure
To initialize the system, complete the following steps.
1. Ensure that the system is powered on, as described in “Powering on the
system” on page 143.
2. Configure an Ethernet port on the personal computer to enable Dynamic Host
Configuration Protocol (DHCP) configuration of its IP address and DNS
settings.
If you do not have DHCP, you must manually configure the personal computer.
Specify the static IPv4 address 192.168.0.2, subnet mask 255.255.255.0,
gateway 192.168.0.1, and DNS 192.168.0.1.
3. Locate the Ethernet port that is labeled T on the rear of a node canister.
Figure 137 shows the rear of the node canister, where ▌1▐ is the technician port.
4. Connect an Ethernet cable between the port of the personal computer that is
configured in step 2 and the technician port. After the connection is made, the
system will automatically configure the IP and DNS settings for the personal
computer if DHCP is available. If it is not available, the system uses the values
that you provided in step 2.
5. After the Ethernet port of the personal computer is connected, open a
supported browser and browse to address http://install. (If you do not have
Figure 137. Storwize V7000 technician port
150 Storwize V7000 Gen2 and Gen2+: Quick Installation Guide
To Next Page
Loading...
