IBM Storwize V7000 Gen2+ - Connecting the SAS Cables

2. Using the supplied SAS cables, connect the control enclosure to the expansion
enclosure at rack position 1, as shown in Figure 22 on page 24.
a. Connect SAS port 1 of the upper node canister in the control enclosure to
SAS port 1 of the left expansion canister in the first expansion enclosure.
b. Connect SAS port 1 of the lower node canister in the control enclosure to
SAS port 1 of the right expansion canister in the first expansion enclosure.
fab10007
4
5
6
7
8
9
1
2
3
*
Figure 21. Connecting the SAS cables
Chapter 2. Installing the system hardware 23