Table 20. Supported expansion enclosure SAS drives (continued)
Description FRU part number
7.68 TB tier 1 flash drive 01LJ071
15.36 TB tier 1 flash drive 01LJ072
Other expansion enclosure parts
Table 21 summarizes the part numbers and feature codes for other parts. The
values are the same for all Storwize V7000 systems that support the 2076-92F
expansion enclosure.
Table 21. Other expansion enclosure parts
Description FRU part number Comments
3 m 12 Gb SAS Cable (mSAS HD) 00AR317
6 m 12 Gb SAS Cable (mSAS HD) 00AR439
16A power cord C19/C20 2 m 39M5388
Enclosure 01LJ607
Note: Replaces
enclosure FRU P/N
01LJ112.
Includes the drive board, signal
interconnect board, and internal power
cables, in an otherwise empty enclosure.
Rail kit 01LJ114
Front fascia (4U front cover) 01LJ116
Display panel assembly 01LJ118
PSU fascia (1U cover) 01LJ120 The fascia must be removed to access the
power supply units.
Power supply unit (PSU) 01LJ122 The expansion enclosure contains 2 PSUs.
Each PSU requires a C19/C20 power
cord.
Secondary expansion module 01LJ124 (for use
with enclosure FRU
P/N 01LJ112)
01LJ860 (for use
with enclosure FRU
P/N 01LJ607
The expansion enclosure supports
two-secondary expansion modules.
Note: The secondary expansion modules
are Tier 2 CRUs. You can replace them or
request that they be replaced by IBM
Service. For example, if the enclosure is
FRU P/N 01LJ112 and it is powered on,
you can contact your service
representative to replace the secondary
expansion module.
CAUTION:
Use caution when you are removing or
replacing a secondary expansion module
from an enclosure with FRU part
number 01LJ112. Avoid contact with the
connectors on the main board.
Fan module 01LJ126 The expansion enclosure contains four fan
modules.
Expansion canister 01LJ128
Cable management arms (CMA) 01LJ130 The part contains the upper and lower
CMA.
Top cover 01LJ132
138 Storwize V7000 Gen2 and Gen2+: Quick Installation Guide
To Next Page
Loading...
