Figure 132 shows an example configuration with two Fibre Channel cables
connected to each canister.
2. If you want to connect additional Fibre Channel cables, make sure to connect
the same number of cables to each canister. Figure 133 shows an example
configuration with four Fibre Channel cables connected to each canister.
3. If a control enclosure is already installed, you can optionally add Fibre Channel
connections between all the control enclosures.
v This involves both the physical installation of the cables and configuring the
correct zoning on the Fibre Channel switches.
Figure 132. Example configuration with two Fibre Channel cables per canister
Figure 133. Example configuration with four Fibre Channel cables per canister
Chapter 2. Installing the system hardware 141
To Next Page
Loading...
