7. Repeat steps 5 on page 49 through 6 on page 50 to install the opposite rail.
8. Install the expansion enclosure in the rack, as described in “Installing or
replacing an expansion enclosure in a rack: 2076-92F.”
Installing or replacing an expansion enclosure in a rack:
2076-92F
Use the following procedure to place the 2076-92F expansion enclosure in a rack
during the installation process. To complete some service tasks, you might also
need to slide the enclosure back in to the rack.
About this task
Important: The 2076-92F expansion enclosure is heavy. Before you install the
expansion enclosure in the rack for the first time or replace it in the rack to
complete a service task, review and implement the following tasks:
v Always use a suitably rated mechanical lift or four persons to raise the enclosure
to install it in the rack. Even after the drives, power supply units, secondary
expander modules, canisters, fans, and top cover are removed, the enclosure
weighs 43 kg (95 lbs).
v Install the expansion enclosure in the lowest position in the rack. Figure 42 on
page 52 shows an example.
Figure 41. Example of the required rack space
Chapter 2. Installing the system hardware 51
To Next Page
Loading...
