Cable management arm
The cable management arm (CMA), which consists of an upper and lower
assembly, are packaged separately from the expansion enclosure. As Figure 30
shows, each CMA assembly is attached to the rear end of the support rails.
Unpacking and installing the enclosure: 2076-92F
Before you unpack and install the 2076-92F expansion enclosure, ensure that you
review and follow the installation checklist and safety notices.
Figure 29. 2076-92F support rails
Figure 30. 2076-92F CMA assemblies
Chapter 2. Installing the system hardware 43
To Next Page
Loading...
