About this task
This task assumes that the following conditions were met:
v The expansion enclosure was moved out from the rack on the slide rails, as
described in “Removing an expansion enclosure from a rack: 2076-92F” on page
89
v The top cover was removed, as described in “Removing the top cover: 2076-92F”
on page 47.
v The display panel assembly was removed, as described in “Removing the
display panel assembly: 2076-92F” on page 116.
Procedure
1. Remove the display panel assembly, which is shown in Figure 112 on page 120,
from its packaging.
Chapter 2. Installing the system hardware 119
To Next Page
Loading...
