EasyManuals Logo

IBM System Storage DS5020 User Manual

IBM System Storage DS5020
260 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
The DS5020 supports configurations of FC disks with or without Full Disk
Encryption (FDE), SATA disks with SATA-FC interposers, solid state disks (SSD),
FC-SAS disks (SAS disks with FC-SAS interposers), or a mix of disk drives. To
install FDE disks in a DS5020, you must purchase the Full Disk Encryption option.
In addition, the FC-SAS disk drives are formatted with 520 byte sectors, and
support T10 Protection Information (T10 PI) capability for the transfer of drive data.
Advanced DS5020 storage management, copy service options, and optional
advanced disaster recovery functions are available for the DS5020, including
FlashCopy
®
, VolumeCopy, and Enhanced Remote Mirroring. To install the SSD or
FC-SAS disks in the DS5020, the minimum versions of controller firmware installed
in the DS5020 must be 7.70.xx.xx or 7.77.xx.xx, respectively.
The DS5020 supports up to four hosts in a redundant direct-attached Fibre Channel
configuration. When using Fibre Channel or Ethernet switches, you can redundantly
connect up to 512 hosts to the DS5020 FC and iSCSI host ports. You can order up
to 128 storage partitions for the DS5020.
DS5020 storage subsystems are equipped with ac power supply and fan units that
support both NEBS/ETSI operating environments and standard IT and office
environments.
The DS Storage Manager client is also available for the DS5020. This storage
management software is designed to help centralize storage management, help
simplify partitioning of the DS5020 storage subsystem, and strategically allocate
storage capacity to maximize storage space.
Base DS5020 features
The base DS5020 storage subsystem is a 3U rack-mount enclosure with the
following features.
Note: Depending on the configuration options that were purchased with your
DS5020, your hardware features miht differ slightly from those in this list.
v Dual RAID controllers, one of the configurations in the following list:
Controllers with 1 GB memory, two standard 8 Gbps FC host ports, and two
standard 4 Gbps FC drive channel ports
Controllers with 1 GB memory, two standard 8 Gbps FC host ports, one
optional 2-port 8 Gbps FC host card, and two standard 4 Gbps FC drive
channel ports
Controllers with 1 GB memory, two standard 8 Gbps FC host ports, one
optional 2-port 1 GB iSCSI host card, and two standard 4 Gbps FC drive
channel ports
Controllers with 2 GB memory, two standard 8 Gbps FC host ports, and two
standard 4 Gbps FC drive channel ports
Controllers with 2 GB memory, two standard 8 Gbps FC host ports, one
optional 2-port 8 Gbps FC host card, and two standard 4 Gbps FC drive
channel ports
Controllers with 2 GB memory, two standard 8 Gbps FC host ports, one
optional 2-port 1 GB iSCSI host card, and two standard 4 Gbps FC drive
channel ports
v Four or eight 8 Gbps FC Small Form-factor Pluggable transceivers (SFPs)
Note: These SFPs will be included only if the DS5020 controllers purchased
have the four additional Fibre Channel host ports
2 IBM System Storage DS5020 Storage Subsystem: Installation, User’s, and Maintenance Guide

Table of Contents

Other manuals for IBM System Storage DS5020

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM System Storage DS5020 and is the answer not in the manual?

IBM System Storage DS5020 Specifications

General IconGeneral
BrandIBM
ModelSystem Storage DS5020
CategoryStorage
LanguageEnglish

Related product manuals