IBM System x3550 M3 Type 4254 User Manual

Setup and configuration overview
ServerGuide setup and configuration overview
When you use the ServerGuide Setup and Installation CD, you do not need setup
diskettes. You can use the CD to configure any supported IBM server model. The
setup program provides a list of tasks that are required to set up your server
model. On a server with a ServeRAID adapter or SAS/SATA controller with RAID
capabilities, you can run the SAS RAID configuration program to create logical
drives.
Note: Features and functions can vary slightly with different versions of the
ServerGuide program.
When you start the ServerGuide Setup and Installation CD, the program prompts you
to complete the following tasks:
v Select your language.
v Select your keyboard layout and country.
v View the overview to learn about ServerGuide features.
v View the readme file to review installation tips for your operating system and
adapter.
v Start the operating-system installation. You will need your operating-system CD.
Important: Before you install a legacy operating system (such as VMware) on a
server with an LSI SAS controller, you must first complete the following steps:
1. Update the device driver for the LSI SAS controller to the latest level.
2. In the Setup utility, set Legacy Only as the first option in the boot sequence in
the Boot Manager menu.
3. Using the LSI Configuration Utility program, select a boot drive.
For detailed information and instructions, go to http://www.ibm.com/support/
entry/portal/docdisplay?lndocid=MIGR-5083225.
Typical operating-system installation
ServerGuide typical operating-system installation
The ServerGuide program can reduce the time it takes to install an operating
system. It provides the device drivers that are required for your hardware and for
the operating system that you are installing. This section describes a typical
ServerGuide operating-system installation.
Note: Features and functions can vary slightly with different versions of the
ServerGuide program.
1. After you have completed the setup process, the operating-system installation
program starts. (You will need your operating-system CD to complete the
installation.)
2. The ServerGuide program stores information about the server model, service
processor, hard disk drive controllers, and network adapters. Then, the
program checks the CD for newer device drivers. This information is stored
and then passed to the operating-system installation program.
3. The ServerGuide program presents operating-system partition options that are
based on your operating-system selection and the installed hard disk drives.
Chapter 3. Configuring the server 121

IBM System x3550 M3 Type 4254 Specifications

General

Brand	IBM
Model	System x3550 M3 Type 4254
Category	Server
Language	English