Results
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 106.
Installing a SAS/SATA 4 Pac HDD option
Use this information to install a SAS/SATA 4 Pac HDD option.
About this task
You can install an IBM System x3550 M3 hot-swap SAS/SATA 4 Pac HDD option
to add four additional 2.5-inch hot-swap hard disk drives in the server. See
http://www.ibm.com/systems/info/x86servers/serverproven/compat/us/ for a
list of supported optional devices. To order a SAS/SATA 4 Pac HDD option,
contact your IBM sales representative or IBM reseller.
The SAS/SATA 4 Pac HDD option kit contains the following components:
v One 2.5-inch hard disk drive backplane (with bracket)
v Four drive bay filler panels
v One SAS signal cable
v One 4 Pac hard disk drive cage and screws
v One bezel (depending on the option you purchase)
To install a SAS/SATA 4 Pac HDD option, complete the following steps:
Figure 74. DVD drive cable connection
Chapter 2. Installing optional devices 97
To Next Page
Loading...
