IBM System x3550 M3 Type 4254 User Manual

6. Remove the adapter, if one is present, from the riser-card assembly.
7. Set the adapter and riser-card assembly aside.
8. Install the adapter in the new PCI riser-card assembly (see “Installing an
adapter” on page 70).
9. Set any jumpers or switches on the adapter as directed by the adapter
manufacturer.
10. If you are installing the PCI riser-card assembly on PCI slot connector 1 on the
system board, remove the PCI filler panel from the rear of the server.
11. Align the PCI riser-card assembly with the PCI slot connector on the system
board; then, press down firmly until the riser-card assembly is seated correctly
in the connector on the system board.
PCI riser
connector 1
PCI riser
connector 2
PCI riser-card assembly
(full-height, half-length adapters)
PCI riser-card assembly
(low-profile adapters)
Figure 40. PCI riser-card assembly removal
Chapter 2. Installing optional devices 69

IBM System x3550 M3 Type 4254 Specifications

General

Brand	IBM
Model	System x3550 M3 Type 4254
Category	Server
Language	English