To Next Page

To Previous Page

Table 5. DSA Preboot messages (continued)

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

v See Chapter 4, “Parts listing, System x3200 M3 Types 7327 and 7328,” on page 133 to determine which components are

customer replaceable units (CRU) and which components are field replaceable units (FRU).

v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a Trained

service technician.

v Go to the IBM support Web site at http://www.ibm.com/systems/support/ to check for technical information, hints, tips,

and new device drivers or to submit a request for information.

Message

number Component Test State Description Action

215-901-xxx Optical Drive

v Verify Media

Installed

v Read/ Write

Test

v Self-Test

Messages and

actions apply to

all three tests.

Aborted Drive media is not

detected.

1. Insert a CD/DVD into the drive or try

a new media, and wait for 15

seconds.

2. Run the test again.

3. Check the drive cabling at both ends

for loose or broken connections or

damage to the cable. Replace the

cable if it is damaged.

4. Run the test again.

5. For additional troubleshooting

information, go to

http://www.ibm.com/support/

docview.wss?uid=psg1MIGR-41559.

6. Run the test again.

7. Replace the CD/DVD drive.

8. If the failure remains, go to the IBM

Web site for more troubleshooting

information at http://www.ibm.com/

systems/support/supportsite.wss/

docdisplay?brandind=5000008

&lndocid=SERV-CALL.

215-902-xxx Optical Drive