iCarsoft CR MAX - Exiting Diagnostics

33
On-Board Monitor
This option allows you to view the results of On-Board Monitor tests.
The tests are useful after servicing or after erasing a vehicle’s control
module memory.
Evap System(mode$8)
This item is used to issue the EVAP system test command.
4.6 Exiting Diagnostics
The Diagnostics application remains open as long as there is active
communication with the vehicle. You must exit the diagnostics operation
to stop all communications with the vehicle before closing the
Diagnostics application.
NOTE
Damage to the vehicle electronic control module (ECM) may occur if
communication is disrupted. Make sure all connections, such as USB
cable and wireless connections, are properly connected at all times
during testing. Exit all tests before disconnecting the test connection
or powering down the tool.
 To exit the Diagnostics application
1. From an active diagnostic screen, tap the Back or ESC
functional button to exit a diagnostic session step-by-step.
2. From the Vehicle Menu screen, tap the Back button on the
top toolbar; or tap the Back button on the navigation bar at
the bottom of the screen.
3. Or tap the Home button on the diagnostics toolbar to exit
the application directly and return to the CR MAX Job Menu.
Once the Diagnostics application is no longer communicating with
the vehicle, it is safe to open other CR MAX applications, or exit the
CR MAX Diagnostic System and return to the Android System’s
Home screen.