8.5-3
Ensure the glass bottle is empty of ink.
PLEASE NOTE: The glass bottle will be automatically emptied at the end of the priming
procedure to avoid damage to the priming kit.
3. Fill the Priming Ink Reservoir to approximately three quarters from full with fresh clean ink,
this is the equivalent to 1 bottle of Priming Ink.
4. Remove the valve cap located on the underside, left hand corner of the printer and
replace with the brass connection located on the ‘Priming Ink Reservoir’ supply pipe. Tighten
the connection by hand ensuring a secure seal between the connector and printer.
5. Care should be taken to avoid thread damage to the valve and connector.
Figure 8.5-3
Ensure the Vacuum tap is in the ‘closed’ position, illustrated below
Figure 8.5-4
Tap in ‘closed’
position
Brass Connection
(Hand Tight)
‘Priming Ink
Reservoir’
Supply Pipe
Vacuum Ta
To Next Page
Loading...