◊ VFO scan watch
q Select the desired memory channel to be watched.
w Push [V/M] to select VFO mode.
e Push [↔ ] for 2 sec. to start full scan, band scan or pro-
grammed scan. (p. 19)
r Push [FUNC] + [(MODE)SET] momentarily to enter set
mode.
•Select a non-band scope screen in advance for color LCD.
t Rotate [DIAL] to select “Priority” or “PRIo.”
•“PRIo” disappears after 1 sec. and “oFF” and “PR” appears when
color LCD is OFF.
y Push [↔] or rotate the tuning dial while pushing [FUNC] to
select priority watch ON or priority watch ON with alert
(BELL).
•If the pocket beep function is activated, the receiver automatically
selects the tone squelch function when the priority watch is se-
lected.
u Push [(MODE)SET] to exit set mode and start the watch.
•The receiver checks the memory channel frequency every 5 sec.
•The watch resumes according to the selected scan resume con-
dition. (p. 22)
•If the priority watch with alert is ON, you can be alerted with
beeps and a flashing “P.B ” or “ë.”
•If the direction finding screen is selected, the receiver automati-
cally selects the simple screen when the priority watch starts.
i Push [V/M] while the display shows the VFO frequency to
stop the watch.
To Next Page
Loading...
Need help?
General
