Icom COMMUNICATIONS RECEIVER IC-R3 - Display Mode Selection; Display Contrast

43
13
OTHER FUNCTIONS
■ Display mode selection
The color LCD can be automatically turned ON when using
with the external DC power
(CP-18A/E or commercially available
DC power supply; 5.5–6.3 V DC with more than 4 A capacity).
q Push [FUNC] + [(MODE)SET] momentarily to enter set
mode.
•Select a non-band scope screen in advance for color LCD.
w Rotate [DIAL] until “Display” or “dISP” appears.
•“dISP” disappears after 1 sec. and “dI” appears.
e Push [↔] or rotate the tuning dial while pushing [FUNC] to
set the color LCD mode to automatic (AUTO) or manual.
•The color LCD will be turned OFF after setting.
r Push [(MODE)SET] to exit set mode.
■ Display contrast
This item adjusts the contrast of the color LCD from 0 % to
100 % in 32 steps.
q Push [FUNC] + [↕] for 2 sec. to turn the color LCD ON.
w Push [FUNC] + [(MODE)SET] momentarily to enter set
mode.
•Select a non-band scope screen in advance.
e Rotate [DIAL] until “Contrast” or “ContRA” appears.
•“ContRA” disappears after 1 sec. and “co” appears.
r Push [↔] or rotate the tuning dial while pushing [FUNC] to
adjust the contrast of the color LCD.
t Push [(MODE)SET] to exit set mode.
RX RX RX
50% (default)Display contrast set
mode
25%
Key Lock : NORMAL
Display : AUTO
Contrast : 50%
Bright : 50%
Back Color : 4
Key Lock : NORMAL
Bright : 50%
Back Color : 4
Key Lock : NORMAL
Bright : 50%
Back Color : 4
Display : AUTO
Contrast : 50%
Display : AUTO
Contrast : 25%
Manual selection
Display mode set
mode
Automatic selection
Key Lock : NORMAL
Display : AUTO
Contrast : 50%
Bright : 50%
Back Color : 4
Key Lock : NORMAL
Display : MANUAL
Contrast : 50%
Bright : 50%
Back Color : 4
Key Lock : NORMAL
Display : AUTO
Contrast : 50%
Bright : 50%
Back Color : 4