36
11
TV OPERATION
■ ATV operation
The IC-R3 ATV-type can receive an amateur TV (FM TV)
within 900–1300 and 2250–2450.095 MHz. The received
video and audio can be output from [A/V OUT] if desired. (p.
5)
q Push [FUNC] + [↕] for 2 sec. to turn the color LCD ON, if
desired.
•Only the audio part of the TV contents can be received.
w Push [↔] one or more times to select the 1200 or 2400
MHz bands.
e Push [FUNC] + [↕] one or more times to select the ama-
teur TV screen.
•“FtV” and frequency appear in the sub LCD.
•The squelch is automatically opened. Push [SQL] to toggle be-
tween squelch open and audio mute conditions.
r Rotate [DIAL] to set the desired frequency.
The video display mode can be selected as positive and
negative depending on the received signal. Push [MODE]
to toggle the display mode, if desired.
◊ ATV memory channel
The receiver has 50 memory channels for storage of often-
used ATV (Amateur TV) frequencies.
q Set the desired frequency with [DIAL].
•Push [↔] to select the 1200 or 2400 MHz band.
•Rotate [DIAL] while pushing [FUNC] for dial select step. (p. 39)
w Push [V/M] for 1 sec. to indicate memory channels.
•Do not hold [V/M] for more than 2 sec., otherwise the previously
selected memory channel will be overwritten.
e Rotate [DIAL] to select the desired channel.
r Push [V/M] for 1 sec. to program.
•Keep pushing for 2 sec. or more to
automatically select the next mem-
ory channel, if desired.
Memory programming after selection, memory transferring
or memory clearing can be used as same manner of regu-
lar memory channels. (pgs. 15, 16)
◊ Sub carrier adjustment
q Push [FUNC] + [↔] for 2 sec. to enter sub carrier set
mode.
w Push [↔] or rotate the tuning dial
while pushing [FUNC] to adjust
sub carrier for better audio re-
ceiving.
e Push [↔] to exit sub carrier set mode.
To Next Page
Loading...
