■ Subaudible tones
(Encoder function)
D Subaudible tones
q Select the mode/channel you wish to set the subaudible
tones to, such as VFO mode or memory/call channel.
w Push [SET ] to enter set mode.
e
Push
[SET]
or
[MONI]
several times until “ ”
and “rt” ap-
pears; or until “ ” and “Ct” appears for tone squelch or
pocket beep use.
• When “d” is displayed in place of the 100 MHz digit, cancel the
DTMF memory encoder in advance. (p. 46)
r Rotate [DIAL] to select and set the desired subaudible fre-
quency.
t Push any key other than [SET] or [MONI] to exit set mode.
NOTE: The subaudible tone encoder frequency can be set
in a memory/call channel temporarily. However, the set fre-
quency is cleared once another memory channel or VFO
mode is selected. To store the tone frequency permanently,
overwrite the channel information.
z Set the mode/channel you wish to set the sub-
audible tones to, such as VFO mode or mem-
ory/call channel.
• The subaudible tone frequency is independently pro-
grammed into each mode or channel.
x Push [
SET
B(D-OFF)] to enter set mode.
c
Push [
SET
B(D-OFF)] or [
ENT
C(T-OFF)] several
times until “ ”
and “rt” appears; or until “ ” and
“Ct” appears for tone squelch or pocket beep
use.
•
When “d” is displayed in place of the 100 MHz digit,
cancel the DTMF memory encoder in advance. (p. 46)
v Push [
YY
] or [
ZZ
] to select and set the desired
subaudible tone frequency.
• Push and hold [
YY
]/[
ZZ
] to change the above tones
continuously.
b Push [
CLR
A(MW)] to exit set mode.
• Subaudible tone frequency list
(unit: Hz)
To Next Page
Loading...
