55
11 PAGER/CODE SQUELCH
■ Pager operation
D Calling a specific station
q Program the desired code channel in advance (p. 53).
w Set the operating frequency.
•
Set the [VOL] and [SQL] to the desired level as in normal opera-
tion.
e Push [BANK ] for 1 sec. then rotate [DIAL] to turn
Pager mode ON.
r Select the desired transmit code channel:
➥ Push [SET] or [MONI].
➥ Rotate [DIAL] to select the code channel.
➥
Push any key other than indicated function keys to return
to the pager operating condition.
• 100 MHz digit shows “P.”
t Push [PTT] to transmit the pager code.
• Transmits the selected transmit codes and your ID automatically.
y Wait for an answer back.
• When the transceiver receives an answer back code, the func-
tion display shows the other member’s ID or group code.
u After confirming a connection, push [BANK ] for
1 sec. then turn the [DIAL] to select the code squelch op-
eration, or repeat the previous key operation again to se-
lect non-selective calling system.
i Communicate with the other party as normal: push [PTT]
to transmit; release to receive.
z Program the desired code channel in ad-
vance (p. 54).
x Set the operating frequency.
c Push [BANK/OPTION] for 1 sec. then
push [
YY
]/[
ZZ
] to turn Pager mode ON.
v Select the desired transmit code channel:
➥ Push [
SET
B(D-OFF)].
➥ Push [
YY
]/[
ZZ
] to select the code chan-
nel.
➥ Push [
CLR
A(MW)] to return to the pager
operating condition.
b Push [PTT] to transmit the pager code.
n Wait for an answer back.
• When the transceiver receives an answer back
code, the function display shows the other
member’s ID or group code.
m After confirming a connection, push
[BANK/OPTION] for 1 sec. then push
[
YY
]/[
ZZ
] to select the code squelch opera-
tion, or repeat the previous key operation
again to select non-selective calling sys-
tem.
, Communicate with the other party as nor-
mal: push [PTT] to transmit; release to re-
ceive.
To Next Page
Loading...
