Icom IC-400PRO - Page 36

31
7
OTHER FUNCTIONS
• STN code (Station to be called)
➥ Select the station code channel with []/[]key.
➥ Set the desired station code following the steps as below.
q
While the station code is displayed, push [DUP] to
enter the station code edit mode.
w Push [DUP] to select the desired digit to be edited.
• Editable digit blinks
e Push []/[]to set the desired code.
• Select “❋” when group code is set.
r Push [DUP] to set the code and the editable digit
move to right automatically.
t Repeat step e and r to input all allowed digits.
y Push [DUP] to set the station code.
• ID code (Self ID number)
➥ Select the ID code channel with []/[]key.
➥ Set the desired ID code in the same way as the station
code setting.
The ID code 12345
Push
[DUP]
The code channel name is displayed.
(if programmed)
The station code 11111
Push
[DUP]
The code channel name is displayed.
(if programmed)
IC-400PRO.qxd 03.6.19 6:13 PM Page 31 (1,1)