Icom IC-905 - Copying the Memory channel contents

6-2
BASIC MANUAL
SD CARD
6
6
Saving the setting data
The Memory channels and the transceiver’s settings
can be saved onto an SD card.
1. Open the SAVE SETTING screen.
»
SET > SD Card > Save Setting
2. Touch “<<New File>>.”
L The le name is automatically set in the following
format: Setyyyymmdd_xx (yyyy: Year, mm: month,
dd: day, xx: serial number).
3. To save the file with the displayed name, touch
[ENT].
L If you want to change the name, delete the name and
reenter it, and then touch [ENT].
4. Touch [YES].
• Saves the data settings.
5. To close the SD CARD screen, push several
times.
Unmounting
Before you remove a card when the transceiver is ON,
be sure to electrically unmount it, as shown below.
Otherwise, the data may be corrupted or deleted.
1. Open the SD CARD screen.
»
SET > SD Card
2. Touch “Unmount.”
3. Touch [YES] to unmount.
• After unmounting, returns to the SD CARD screen.
L To cancel unmounting, touch [NO].
4. Remove the card from the transceiver.
• Push in the card until a ‘click’ sounds to unlock the
card, and then pull it out.
2Pull out
1Push in
5. To close the SD CARD screen, push several
times.
When the transceiver is OFF
You can remove the card starting from step 4 of the
steps described above.