8-5
BASIC MANUAL
SET MODE
8
8
»
SET > Function
[SPEECH/LOCK] Switch (Default: SPEECH/LOCK)
Selects
action.
• SPEECH/LOCK: Pushing turns ON the Voice
down turns the Lock function
• LOCK/SPEECH: Pushing turns the Lock
down turns ON the Voice
Lock Function (Default: MAIN DIAL)
This function electronically locks
or the
panel display* to prevent accidental changes.
*
Keys and dials are also locked except for and .
Memo Pad Quantity (Default: 5)
Sets the number of memo pad channels to 5 or 10.
Function of Touch for 1 sec MHz Digits
1 second.
• Band Stacking Register:
Opens the BAND STACKING
REGISTER screen.
•
MAIN DIAL Auto TS (Default: High)
Sets the Auto Tuning Step function for
.
When rapidly rotating , the tuning step
automatically changes according to the rotation speed.
•
• Low: Approximately two times faster.
•
Approximately two times faster when the
MIC Up/Down Speed
Selects the steps per second when changing
an operating frequency by holding down the
• Slow: Low speed (25 tuning steps/second)
•
AFC Limit (Default: ON)
Selects whether or not to limit the operating range of
•
• ON:
[NOTCH] Switch (SSB) (Default: Auto/Manual)
[NOTCH] Switch (AM) (Default: Auto/Manual)
Selects the Notch function used in the SSB or AM mode.
• Auto: Only the Auto Notch function can be
used.
• Manual: Only the Manual Notch function can
be used.
• Auto/Manual: Both the Auto and Manual Notch
functions can be used.
SSB/CW Synchronous Tuning
to match the CW pitch when the operating mode is
toggled between SSB and CW.
•
• ON: When the operating mode is changed
between SSB and CW, the operating
CW Normal Side (Default: USB)
Selects the carrier point in the CW normal mode.
• LSB: Sets the carrier point to the LSB side.
• USB: Sets the carrier point to the USB side.
Power OFF Setting (for Remote Control)
(Default: Shutdown only)
Selects whether or not to display the Standby/Shutdown
option dialog after holding down for 1 second.
• Shutdown only: Shuts down the transceiver when
• Standby/Shutdown:
Displays the Standby/Shutdown
To Next Page
Loading...
