10-2
BASIC MANUAL
MAINTENANCE
10
10
Resetting
D Partial reset
1. Open the RESET screen.
»
SET > Others > Reset
2. Touch “Partial Reset.”
3. Touch [YES].
L After resetting, the default VFO mode screen is
displayed.
D All reset
1. Open the RESET screen.
»
SET > Others > Reset
2. Touch “All Reset.”
3. Touch [NEXT].
4. After carefully reading the displayed message,
touch [YES] to perform the All reset.
L After resetting, the default VFO mode screen is
displayed.
When you cannot enter the Set mode
If a touch screen operation error or an unexpected
operation occurs, you cannot enter the Set mode. In
this case, perform an All reset, as described below:
1. Turn OFF the transceiver.
2. While holding down and , push
.
L If you cannot turn the transceiver ON or OFF by
using , perform an All reset by connecting
an external power source while holding down
and .
To Next Page
