8-2
BASIC MANUAL
8
SET MODE
Function
»
SET > Function
Beep Level (Default: 50%)
Sets the beep output level.
L
Beep Level Limit (Default: ON)
Selects whether or not to limit the volume up to a
•
• ON: Limits the volume level.
Beep (Conrmation) (Default: ON)
•
• ON: A beep sounds when a switch is pushed or
the touch panel is touched.
L If “Beep Level” is set to “0%,” no beep sounds.
Home CH Beep (Default: ON)
L
frequency or the Home Channel Memory is selected, the
Home CH Beep sounds.
L In the DR screen, when the Home Channel Access
•
• ON: Sounds a beep when you select the Home
Channel.
Band Edge Beep (Default: ON (Default))
Selects an option for the Band Edge Beep function.
•
• ON (Default): A beep sounds when you tune out
of, or back into the default amateur
band’s frequency range.
• ON (User): A beep sounds when you tune out
of, or back into a user programmed
amateur band’s frequency range.
• ON (User) & TX Limit:
A beep sounds when you tune out
of, or back into a user programmed
amateur band’s frequency range.
Transmitting is inhibited outside of the
range.
L If “Beep Level” is set to “0%,” no beep sounds.
Tone Control/TBW
»
SET > Tone Control/TBW > RX
SSB, AM, FM, DV, CW, RTTY
RX HPF/LPF (Default: – – – – – – – – –)
L If this item is set, the “RX Bass” and “RX Treble” items
are automatically set to “0.”
SSB, AM, FM, DV, ATV
RX Bass (Default: 0)
RX Treble (Default: 0)
Sets the bass or treble level of the receive audio.
»
SET > Tone Control/TBW > TX
SSB, AM, FM, DV, ATV
TX Bass (Default: 0)
TX Treble (Default: 0)
Sets the bass or treble level of the transmit audio.
SSB
TBW (WIDE) (Default: 100 – 2900)
TBW (MID) (Default: 300 – 2700)
TBW (NAR) (Default: 500 – 2500)
Sets the transmission passband width to wide, mid,
frequencies.
SSB-D
TBW (Default: 300 – 2700)
Sets the transmission passband width by changing
NOTE: The default settings shown below are for the
USA transceiver version. The default settings may
To Next Page
Loading...
