8-9
BASIC MANUAL
SET MODE
8
8
»
SET > DV/DD Set > DV Fast Data
Fast Data
function for data communication in the DV mode.
audio frames to send data approximately 3.5 times
faster than the normal speed. So, no audio can be
sent.
•
950 bps).
• ON: Sends data at a fast speed (approximately
3480 bps).
L Even if “ON” is selected, when you push the microphone’s
[PTT], the data is sent at the slow speed, because the
audio frame is used for the audio transmission.
The GPS data speed is set in “GPS Data Speed.”
GPS Data Speed (Default: Slow)
Sets the GPS data speed when the data is sent using
• Slow: Sends GPS data in the slow speed
(approximately 950 bps).
•
(approximately 3480 bps).
TX Delay (PTT) (Default: 2sec)
Sets the time for when the transceiver returns to
mode using the microphone’s [PTT].
•
returns to receive.
• 1 ~ 10sec: After releasing [PTT], the transceiver
mode for this set period.
When the TX data is completely sent
within this set period, the transceiver
automatically returns to receive.
NOTE: This function is usable only when “DV Data
TX” is set to “PTT.”
DV/DD Set
»
SET > DV/DD Set
Standby Beep
(Default: ON (to me:Alarm/High Tone)
This function sounds a beep after a received signal
disappears, in the DV mode.
•
disappears.
• ON: Sounds a beep after a received signal
disappears.
• ON (to me:High Tone):
Sounds a high pitched beep when a received
signal that is addressed to your call sign (MY)
disappears. When any other received signal
disappears, a regular beep sounds.
• ON (to me:Alarm/High Tone):
Sounds alarm (PiRoPiRoPiRo) when a
received signal that is addressed to your
call sign (MY) disappears. When any other
received signal disappears, a regular beep
sounds.
L The standby beep sounds even when “Beep
L The standby beep output level depends on the “Beep
level” setting.
Auto Reply
Voice. This function automatically replies to a call
addressed to your own call sign (MY), even if you are
away from the transceiver.
•
• ON: Replies with your own call sign (MY). (No
audio reply is sent)
• Voice: Replies with your call sign (MY) and any
Auto Reply message recorded on the SD
card (up to 10 seconds). If no SD card is
inserted, or no message is recorded, only
your call sign is transmitted. The transmitted
audio can be monitored.
L When “ON” or “Voice” is selected, the Automatic Reply
microphone’s [PTT].
DV Data TX (Default: Auto)
Selects whether to manually or automatically transmit
data in the DV mode.
• PTT: Push the microphone’s [PTT] to manually
transmit data.
• Auto: When data is input from a PC through the
[USB] port, the transceiver automatically
transmits it.
To Next Page
Loading...
