Icom IC-905 - Speaker Microphone

1-4
BASIC MANUAL
PANEL DESCRIPTION
1
1
Speaker microphone Top panel/Bottom panel (RF unit)
1[PTT] SWITCH
Hold down to transmit, release to receive.
NOTE: To maximize the readability of your signal,
hold the microphone 5 to 10 cm (2 to 4 inches)
from your mouth, and then speak at your normal
voice level.
2[A] KEY
Push to activate the assigned function of the [A]
key. (Default: Home CH)
[B] KEY
Push to activate the assigned function of the [B]
key. (Default: VFO/MEMO)
3
z Push to change the operating frequency or
Memory channel.
z Hold down to continuously change the frequency
or Memory channel.
TIP: You can change the assigned function of the
[▲],[▼],[A],and[B]keysinthefollowingitem.
»
SET > Function > Remote MIC Key
1GPS (GNSS) ANTENNA CONNECTOR
[GPS ANT] (p. 13-5)
Attach a supplied GPS antenna.
2140/430/1200 MHz ANTENNA CONNECTOR
[144/430/1200 MHz ANT] (p. 13-5)
 Connecta50ΩTypeNcoaxconnectorforthe144,
430, and 1200 MHz band.
32400 MHz ANTENNA CONNECTOR
[2400 MHz ANT] (p. 13-5)
 Connecta50ΩTypeSMAcoaxconnectorforthe
2400 MHz band.
45600 MHz ANTENNA CONNECTOR
[5600 MHz ANT] (p. 13-5)
 Connecta50ΩTypeSMAcoaxconnectorforthe
5600 MHz band.
5CONNECTION CABLE to the CONTROLLER
Connect to the controller with a supplied cable.
6REFERENCE SIGNAL OUTPUT
[REF OUT 10MHz/-10dBm] (p. 13-5)
Output a 10 MHz reference signal through the BNC
connector.
7ACC SOCKET [ACC] (p. 13-4)
Connects to devices to control an external unit or to
control the transceiver.
2
1
3
5
7
6
4
1
2
3
Top panel
Bottom panel
Mic element