2-2
BASIC MANUAL
INSTALLATION AND CONNECTIONS
2
2
Non-Icom DC power supply
Connecting an external DC power supply
Conrm that the transceiver is OFF before connecting
the DC power cable.
L When connecting a DC power cable, the transceiver
needs:
• DC 13.8 V (Capacity: At least 5 Amps)
• A power supply with an over current protective line,
and low voltage uctuation or ripple.
CAUTION: DO NOT touch the transceiver’s surface
when disconnecting the cable immediately after
operation. The transceiver’s surface becomes hot
after continuously transmitting for long periods of
time.
_+
Center positive
Controller
To [DC 13.8 V] jack
Supplied DC power cable
DC 13.8 V/5.5 A or more
RedBlack
Fuses
Attach the Ferrite
EMI lter to the
DC power cable.
To Next Page
Loading...
