8-3
BASIC MANUAL
SET MODE
8
8
FM/DV Center Error (Default: ON)
The RX indicator shows the received signal deviation.
blinks green.
•
• ON: Turns ON the function.
Auto Power OFF
transceiver after inactivity for this set period of time.
L
operate the transceiver during this period of time, the
•
• 30/60/90/120min:
this set period of time.
»
TX Delay
144M
430M
1200M
2400M
5600M
10G
Sets the TX delay time on each band.
L If an external equipment’s rise time is slower than that
damage the IC-905 or the external device. To prevent
wave or timing damage occurs.
L
Po
Tx
Delay time (ms)
»
SET > Function
Time-Out Timer (Default: 10min)
30 minutes to prevent an accidental prolonged
transmission.
L
PTT Lock
accidental transmissions, this function inhibits all
transmissions.
•
• ON: Inhibits all transmissions.
»
SPLIT
Quick SPLIT (Default: ON)
This function automatically turns ON the SPLIT
•
• ON: Turns ON the function.
SPLIT Oset
and transmit frequencies for the Quick SPLIT function.
SPLIT LOCK
The SPLIT LOCK function enables you to adjust the
transmit frequency while holding down
, even
while the Dial Lock function is activated. To prevent
accidentally changing the receive frequency by
rotating , use both the SPLIT LOCK and
Dial Lock functions (p. 3-8).
•
• ON: Turns ON the function.
To Next Page
Loading...
