8-22
BASIC MANUAL
8
SET MODE
SD Card
»
SET > SD Card
TX/RX Picture View
Displays the pictures that are saved on the SD card.
L The transceiver cannot display the picture while
transmitting picture data.
L The transceiver can display up to 500 pictures.
Firmware Update
Firmware Update (CX-10G)
Format
If you use a brand new SD card, be sure to format it in
the transceiver.
Unmount
Unmounts the SD card.
Before you remove a card when the transceiver is ON,
be sure to electrically unmount it. Otherwise, the data
may be corrupted or deleted.
Others
»
SET > Others > Information
Version
MAC Address (Controller)
Displays the controller’s MAC address.
MAC Address (RF Unit)
SERIAL NO. (Controller)
Displays the controller’s serial number.
SERIAL NO. (RF Unit)
SERIAL NO. (CX-10G)
Displays the CX-10G’s serial number.
»
SET > Others > Clone
Clone Mode
Selects to enter the clone mode to read or write the
CS-905 data from or to the PC.
L Restart the transceiver to cancel the clone mode.
»
SET > Others
Touch Screen Calibration
Touch to adjust the touch screen.
L See the Advanced Manual for details.
»
SET > Others > Reset
Partial Reset
L See page 10-2 for details.
All Reset
Clears all data and returns all settings to their factory
so on will all be cleared, so you will need to rewrite
your operating settings.
L See page 10-2 for details.
To Next Page
Loading...
