Icom IC-A210E - History Memory Channel; Clearing the Memory Contents ( Regular and Group Memory Channels Only)

14
3
MEMORY OPERATION
n
History memory channel
The transceiver has 10 history memory channels.
The standby frequency is stored into a history memory chan-
nel when pushing [↔].
The frequency is stored into the history memory channel in
order from “CH01” to “CH10.”
q Push [RCL] to enter the memory mode.
 •Thechannelnumberappears.
 •Thememorychannelnamealsoappearsifithasbeenentered.
w Rotate [O-DIAL] to select the history memory channel.
 •“HISTORY”appears.
e Rotate [DIAL] to select the desired channel.
•Push[↔] to exchange the history memory channel frequency
to the active frequency if necessary.
r Push [RCL] to exit the memory mode.
n
Clearing the memory contents
( Regular and group memory
channels only)
Unwanted memory channels can be cleared.
q Push [RCL] to select memory mode.
 •Thechannelnumberappears.
 •Thememorychannelnamealsoappearsifithasbeenentered.
w Rotate [O-DIAL] to select the memory channel type.
 •Selectfromregularmemorychannelorgroupmemorychannel.
e Rotate [DIAL] to select the desired channel.
r Push [MEM], then rotate [O-DIAL] to select “DELETE.”
 •Thememorychannelnumberblinks.
t Push [MEM] to delete the memory channel data.
 •“------------”appearsmomentarily,thenthenextselectable
channel appears.
y Push [RCL] to exit the memory mode.
CH01
127.005
122.00
RX
HISTORY
CH01
127.000
127.000
122.00
RX
MEMORY
ÅDELETE Ç
CH01
122.00
RX
MEMORY
NOTE: Instead of steps r and t, holding down [MEM]
for 2 seconds after step e also allows delete or revive op-
eration.