13
OTHERS
13-5
F1 F2 F3
[F1] [F2] [F3] Power key
Copying data from a transceiver
Master: Mobile Segment types
Step 1: Entering the Programming mode (Master)
1. While holding down [F2] and [F3], turn ON the
transceiver. Continue holding down [F2] and [F3]
for about 3 seconds.
• 2 beeps sound.
• The transceiver enters the Programming mode.
2. Hold down [F1] for 1 second to enter the Set mode.
3. Push [F2] or [F3] to select the “C0” screen.
• The transceiver enters the Programming mode.
Step 2: Turning ON the transceiver (Sub)
Step 3: Copying data (Master)
Push the Power key to start copying data to the Sub
transceiver.
Step 4: Complete (Master/Sub)
After copying is completed, the Master and Sub
transceivers automatically restart.
• The user can operate the Sub transceiver with the loaded
data.
Step 1: Entering the Programming mode (Master)
1. Set [Selector] to Channel 16.
2. While holding down [F2] and [F3], turn ON the
transceiver. Continue holding down [F2] and [F3]
for about 3 seconds.
• 2 beeps sound.
• The transceiver enters the Programming mode.
Step 2: Turning ON the transceiver (Sub)
Step 3: Copying data (Master)
Push the [PTT] to start copying data to the Sub
transceiver.
Step 4: Complete (Master/Sub)
After copying is completed, the Master and Sub
transceivers automatically restart.
• The user can operate the Sub transceiver with the loaded
data.
D Copying data (Continued)
Master: Portable Non-display types
[VOL]
[PTT]
[F2]
[F3]
[Selector]
To Next Page
Loading...
