Beep tone
Beep
Scan type
Scan type
Scan resume timer
Scan timer
Dual/tri-watch of COMMANDMIC
Dual/Tri COMMANDMIC
LCD contrast
Contrast
Rotate [CHANNEL]
Push when using HM-134
˘Scan Type
˘Scan Timer
˘Beep
--Set Mode--
˘Contrast
˘Internal Speaker
˘Dual/Tri COMMANDMIC
˘Foghorn Frequency
˘Exit
Foghorn FrequencyFoghorn Frequency
and
Internal Speaker
items are
not selectable when using HM-134.
■ Set mode programming
Set mode is used to change the conditions of the trans-
ceiver’s functions: scan type (normal or priority), scan resume
timer, dual/tri-watch of COMMANDMIC, transceiver’s beep
tone, internal speaker, LCD contrast and automatic foghorn
frequency.
Available functions may differ depending on dealer setting.
q Turn power OFF.
w While pushing [16•C], turn power ON to enter set mode.
e After the display appears, release [16•C].
r Rotate [CHANNEL] to select the desired item, push [ENT].
Or push [16•C] to select the item when using an optional
HM-134.
t Rotate [CHANNEL] to select the desired condition of the
item. Use [Y]/[Z] when using an optional HM-134.
y Rotate [CHANNEL] to select “Exit,” push [ENT] to exit
set mode and returns to normal operation condition
• SET MODE CONSTRUCTION
To Next Page
Loading...
