Icom IC-M601 - SECTION 11 WIRING DIAGRAM

offered by Busse-Yachtshop.com
■ Supplied accessories
The following accessories are supplied
Qty.
q Microphone (HM-137) 1
w DC power cable (OPC-1174) .......................................... 1
e Microphone hanger ........................................................ 1
r Mic hanger screws (3 × 16) ............................................ 2
t Mounting bracket ............................................................ 1
y Knob bolts for mounting bracket...................................... 2
u Mounting screws (5 × 20) ............................................... 4
i Spring washers (M5) ...................................................... 4
o Flat washers (M5) ........................................................... 4
!0 Accessory connectors (3 pin, 10 pin) .................... 1 each
!1 Sponges .......................................................................... 2
!2 OPC-1096 ......................................................................1
■ Antenna
A key element in the performance of any communication sys-
tem is an antenna. Ask your dealer about antenna and the
best places to mount them.
■ Fuse replacement
One fuse is installed in the supplied DC power cable. If a fuse
blows or the transceiver stops functioning, track down the
source of the problem, if possible, and replace the damaged
fuse with a new, rated one.
■ Cleaning
If the transceiver becomes dusty or dirty, wipe it clean with a
soft, dry cloth.
AVOID the use of solvents such as benzene or al-
cohol, as they may damage transceiver surfaces.
Fuse rating: 10 A
qwe
r
t
y
u
!1
!0
!2
i
o
40
9
CONNECTIONS AND MAINTENANCE