■ Function display
q BUSY/TRANSMIT INDICATOR (p. 10)
➥ “BUSY” appears when receiving a signal or when the
squelch opens.
➥ “TX” appears while transmitting.
w TAG CHANNEL INDICATOR (p. 15)
Appears when a tag channel is selected.
e SCAN INDICATOR
➥ Either “NORMAL SCAN” or “PRI-SCAN 16” scan
type appears while scanning. (p. 15)
➥ “DUAL 16” appears during dualwatch; “TRI 16” ap-
pears during tri-watch. (p. 13)
r POSITION INDICATOR
➥ Shows the GPS position data.
•“??” may blink every 2 sec. instead of position data; when the
GPS position data is invalid. In such a case, the last position
data is held for up to 23.5 hours.
•“??” may blink every 2 sec. instead of position data 4 hours
after the position data is input manually, up until 23.5 hours
have past.
➥ “No Position” appears when no GPS receiver is
connected and no position data is input manually.
t TIME ZONE INDICATOR
➥ “Local” appears when the offset time data in the ‘Set
up’ menu is entered. (p. 29)
➥ “No Time” appears when no GPS receiver is con-
nected and no time data is input manually.
To Next Page
Loading...
