55
13
HM-134 REMOTE-CONTROL MICROPHONE
13
■ Call channel programming
q While pushing and holding [H/L],
push [DIAL] several times to select
the desired channel group (USA or
INT) to be programmed. (depends
on transceiver’s version)
w Push and hold [16•C] for 1 sec. to
select the call channel of the se-
lected channel group.
•“CALL” and call channel number ap-
pear.
e Push and hold [16•C] again for
3 sec. (until long beep changes to
2 short beeps) to enter call channel
programming condition.
•Call channel number and channel
group to be programmed flashes.
r Push [Y]/[Z] to select the desired
channel.
t Push [16•C] to program the dis-
played channel as the call channel.
• The call channel number and channel
group stop flashing.
■ Starting a scan
q While pushing and holding [H/L], push [DIAL] once or twice
to select the channel group (USA or INT), if desired.
w Push [SCAN•TAG] to start priority or normal scan.
• “SCAN” appears during normal scan.
• The priority channel readout indicates “16”, and “P” and “SCAN”
indicators appear during priority scan.
•When a signal is received, scan pauses until the signal disap-
pears or resumes after pausing 5 sec. according to set mode set-
ting (Channel 16 is still monitored during priority scan).
• Push [Y]/[Z] to check the scanning tag channels, to change the
scanning direction or resume the scan manually.
e To stop the scan, push [SCAN•TAG].
• “SCAN” disappears.
• Pushing [PTT], [16•C] or [DIAL] also stops the scan.
To Next Page
Loading...
