Icom IC-M94D - PREPARATION; Entering the MMSI Code

11
5
PREPARATION
■ Entering the MMSI code
The Maritime Mobile Service Identity (MMSI: DSC self ID) code
consists of 9 digits. You can only enter the code when turning
ON the transceiver for the rst time.
This initial code entry can be done only once.
After entering, it can be changed only by your dealer or
distributor. If your MMSI code has already been entered, this
entry is not necessary.
1. Hold down [
] to turn ON the transceiver.
• Three short beeps sound, and “Push [ENT] to register your
MMSI” is displayed.
2. Push [ENT] to start entering the MMSI code.
• The “MMSI Input” screen is displayed.
L To skip the entry, push [CLR] twice.
If you skip the entry, you cannot make a DSC call. To enter
the code after skipping, turn OFF the power, and then turn
it ON again.
3. Enter the MMSI code.
TIP:
• Select a number using [◄] and [►].
• Push [ENT] to enter the selected number.
• Select “←” or “→,” to move the cursor.