Icom IC-M94D - Entering the Position and Time

23
9
DSC OPERATION
D Deleting an entered ID
(Example: Deleting an Individual ID: STATION 2)
1. Open the “Individual ID” screen.
[MENU] > Settings > DSC > Individual ID
2. Select “STATION 2.”
3. Push
.
• “Delete the ID. Are you sure?” is displayed.
4. Push to delete.
L Push to cancel the deletion.
• The selected ID is deleted, and then returns to the previous
screen.
TIP: You can edit an ID and its name by pushing in step 3.
■ Entering the position and time
A Distress call should include the vessel’s position, date, and time. If no GPS data is
received, manually enter the position and Universal Time Coordinated (UTC) time.
NOTE:
• The manual entry is disabled while valid GPS data is received.
• The manually entered position and time is valid only for 4 hours, or until turning OFF
the transceiver.
1. Open the “Position Input” screen.
[MENU] > Settings > DSC > Position Input
2. Enter the latitude.
TIP:
• Select a number or a compass direction using [▲]/[▼]/
[◄]/[►].
• Push [ENT] to enter the selected number.
• Select “←” or “→” on the screen to move the cursor.
• Select “Next,” and then push [ENT] to change the entry
between latitude, longitude, and UTC.
3. Enter the longitude and the UTC time.
L See the TIP in step 2 to enter.
4. Select “Finish,” and then push [ENT] to set the entered
position and time.
• The transceiver returns to the previous screen.
L The entered position and time are displayed on the
operating screen.
L “Manual” is displayed next to the time display.