Icom IC-M94D - Sending DSC Calls (Other)

28
9
DSC OPERATION
9
10
15
18
13
11
16
14
12
17
1
7
4
2
8
5
3
6
■ Sending DSC calls (other)
NOTE: To ensure proper DSC operation, be sure to correctly adjust the “CH 70 SQL
Level” item on the Menu screen. (p. 43)
D Sending an Individual call
An Individual call enables you to send a DSC signal to only a specic station. You can
communicate after receiving the Acknowledgement “Able to comply.”
1. Push
.
• The “Compose Other” screen is displayed.
L You can also display the “Compose Other” screen by
selecting the “Compose Other” item on the Menu screen.
2. Select “Message Type,” and then push [ENT].
3. Select “Individual,” and then push [ENT].
• Returns to the “Compose Other” screen.
4. Select “Address,” and then push [ENT].
5. Select the station to send an Individual call to, and then
push [ENT].
• Returns to the “Compose Other” screen.
L You can also select “Manual Input” to manually enter the
target station ID.
6. Select “Channel,” and then push [ENT].
7. Select a channel to assign, and then push [ENT].
L The assigned channels are preset by default.
8. Push to send the Individual call.
• “Transmitting Individual Call” is displayed, and then “Waiting
for ACK” is displayed.
L If Channel 70 is busy, the transceiver stands by until the
channel becomes clear.
9. When you receive an Acknowledgement “Able to comply”:
• An alarm sounds.
• The screen to the right is displayed.
10. Push to turn OFF the alarm.
• The channel assigned in step 7 is automatically selected.
L If the called station cannot use the channel that you
assigned, a di󰀨erent channel is selected by the other
station.
11. Hold down [PTT] to communicate.
TIP: If you received an Acknowledgement “Unable to
comply”:
1. Push
to turn OFF the alarm.
• The Acknowledge information is displayed.
2. Push , and then to return to the
operating screen.