59
11
OTHER FUNCTIONS
■ Navigation
The transceiver assists you to navigate to a selected destination from your current position.
You can select a AIS target during navigation.
L The function cannot work while in the MOB mode.
NOTE: IC-M94D’s Navigation function is a supplemental aid to navigation only, and is
not intended to be a substitute for primary Navigation equipment.
Using
:
1. Push
.
• The “Waypoint” screen is displayed.
2. Push [▲] or [▼] to select a waypoint.
L Push to sort the waypoints by Name or Range.
3. Push or [ENT] to start navigation.
• The plotter screen is displayed, and the transceiver starts to
navigate.
• is displayed on the plotter screen.
4. Push the Software Key below for your next operation.
:
(DSC)
Displays the “Compose Other” screen to send
an Individual call. (p. 28)
L Displayed only when a target is selected.
:
(Stop)
Stops navigation. (p. 60)
:
(MOB)
Starts the MOB mode. (p. 58)
L The transceiver automatically exits the
Navigation mode.
:
(Range)
Selects the display range. (p. 46)
:
(Target ▲)
Selects the farthest target from your vessel.
:
(Target ▼)
Selects the closest target to your vessel.
:
(Detail)
Displays the details on the selected target.
(p. 50)
L Displayed only when the target is selected.
L Push
to the return the plotter screen.
:
(List)
Selects the list screen that you want to
display. (p. 47)
D Starting navigation
There are 3 ways of setting a destination, using , selecting in the AIS list, and
selecting in the Waypoint list.
NOTE:
• A popup screen is displayed when the vessel arrives at or near the destination. To stop
the function, push any key.
L When the Audible Alarm function is set to “ON,” an alarm also sounds. (p. 60)
• If the transceiver is turned OFF during navigation, the transceiver continues navigation.
To Next Page
Loading...
Need help?
General
