39
9
DSC OPERATION
D Receiving a Test call
When a Test call is received:
• An alarm sounds.
• “RCVD Test Call” is displayed.
1. Push
to turn OFF the alarm.
2. Push the Software Key below for your next operation.
:
(Ignore)
Ignores the call and returns to the operating
screen.
• The call is saved in the DSC Log.
• “
” blinks continuously until you display the
call message.
:
(Hold)
Puts the received call on hold, and returns to the
operating screen.
L You can check the DSC calls that are on hold in
the Unread List. (p. 41)
:
(Able
Comply)
Sends a Test Acknowledgement “Able Comply.”
• The call is saved in the DSC Log.
:
(Accept)
Accepts the call.
• Displays the received call’s information.
• The call is saved in the DSC Log.
• Push
, and then push to send a
Test Acknowledgement. (p. 32)
• Push
to resend.
NOTE: If the Auto ACK function is set to “Auto,” the Test Acknowledgement call is
automatically sent to the calling station when the call is received. (p. 42)
If the function is set to “Manual,” the following screens are displayed.
To Next Page
Loading...
Need help?
General
