Icom IC-T10 - Detaching;Attaching the Jack Cover

7
OPTIONS
7-3
D Detaching/Attaching the jack cover
The jack cover is attached using the M2 × 6 mm
screws.
Detaching: Attaching:
1. Remove the screws (1).
2. Remove the jack cover (2).
1. Attach the jack cover (1).
2. Attach the screws (2).
CAUTION:
• DO NOT use the transceiver without the jack
cover or the optional equipment attached. The
transceiver meets IP67 requirements for dust-tight
and waterproof protection only when the jack cover

attached.
• DO NOT use other than the supplied screws.
q
w
q
q
w
Options