34
8
SCAN OPERATION
■ Scan resume
condition
When a signal is received during
scanning, the scan resume condi-
tion determines what action the
transceiver takes. The transceiver
has 2 scan resume conditions avail-
able as illustrated at right. Use
SET
MODE
to select the one which best
suits your needs.
q Push [8•
SET
] after pushing [A•
FUNC
] to enter
SET MODE
.
w Push [Y]/[Z] several times until “SCP” or “SCt” appears.
e Rotate [VOL] to select the desired scan resume condition.
• Pause scan: When receiving a signal,
scan pauses on the signal until it disap-
pears. Resumes 2 sec. after the signal
disappears.
Timer scan: When receiving a signal,
scan pauses on the signal for 5 sec., 10
sec. or 15 sec., then resumes.
r Push [#•
ENT
] to set and exit
SET MODE
.
To Next Page
Loading...
Need help?
General
