Icom ID-31A - Mode Selection: VFO and Memory

21
5
BASIC OPERATION
New2001 New2001
■ Mode selection
D VFO mode
The VFO mode is used to set the desired frequency.
Push [V/MHz] ➥
to select the VFO mode.
D Memory mode
Memory mode is used for operation on memory channels,
which store programmed frequencies.
Push q [M/CALL]
once or twice to select the memory
mode.
 •“ ” appears when the memory mode is selected.
 •Push[M/CALL]
again to select Call channels. The Memo-
ry mode or Call channels are alternately selected.
• VFO mode display
• Memory mode display
Appears
WhatisaVFO?
VFO is an abbreviation of Variable Frequency Oscillator. Fre-
quencies for both transmitting and receiving are generated
and controlled by the VFO.
Rotate w [DIAL] to select a desired memory channel.
 •Onlyprogrammedmemorychannelscanbeselected.
 •Seep.28formemoryprogrammingdetails.