New2001
iv
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
CAUTION: DO NOT
use harsh solvents such as ben-
zine or alcohol to clean the transceiver, because they can
damage the transceiver’s surfaces.
DO NOT operate the transceiver near unshielded electri-
calblastingcapsorinanexplosiveatmosphere.
DO NOT push the PTT unless you actually intend to trans-
mit.
BE CAREFUL! The transceiver will become hot when op-
erating it continuously for long periods of time.
DO NOT use or place the transceiver in direct sunlight
or in areas with temperatures below –20°C (–4˚F) or above
+60°C (+140˚F).
Place the unit in a secure place to avoid inadvertent use by
children.
BE CAREFUL! The transceiver meets IPX7* require-
ments for waterproof protection. However, once the trans-
ceiver has been dropped, waterproof protection cannot be
guaranteed because of possible damage to the transceiver's
case or waterproof seal.
*OnlywhentheBP-271orBP-272(option),exibleantenna,
[MIC/SP] cap, [DATA/DC IN] cap and [micro SD] slot cap
are attached.
The BP-273 meets IPX4 requirements for splash resistance.
When it is connected, the transceiver corresponds to IPX4.
Even when the transceiver power is OFF, a slight current still
flows in the circuits. Remove the battery pack or batteries from
the transceiver when not using it for a long time. Otherwise,
theinstalledbatterypackorbatterieswillbecomeexhausted,
and will need to be recharged or replaced.
PRECAUTIONS
To Next Page
Loading...
