Icom ID-31A - Page 61

52
8
TROUBLESHOOTING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
PROBLEM POSSIBLE CAUSE SOLUTION REF.
After your call, the repeater
does not transmit a reply.
•Therepeatersettingiswrong.
•Thetransceiverisoutoftherepeaterrange,or
your transmission does not reach the repeater.
•Setthecorrectrepeater.
•Correcttherepeaterfrequency,frequencyoffset,or
duplexsetting.
•Trytoaccessanotherrepeater.
Advanced
Instruction
Section 3
After your call, the repeater
replies ‘UR?’ and its call
sign.
•Thecallwassuccessfullysent,butnostation’s
signal was immediately received.
•Waitforawhile,andtryitagain.
After your call, the repeater
replies‘RX’ or‘RPT?’and
the call sign of its gateway
repeater.
•MYcallsignhasnotbeenset.
•Your callsign hasnotbeenregisteredtothe
D-STAR Server. Or it’s wrong.
•Yourcallingstationcallsignhasnotbeenregis-
tered to the D-STAR Server. Or it’s wrong.
•SettheMYcallsign.
•RegisteryourcallsigntotheD-STARServer.Orcon-
firm the registration of your call sign.
•Asktheserver’sadministratoraboutyourcallingsta-
tion’s call sign.
After your call, the repeater
replies‘RPT?’andcallsign
of the called repeater.
•TheD-STARcannotconnecttothecalledre-
peater, or it’s busy.
• Wait for a while, and try it again.
After your call, the repeater
replies‘RPT?’ and its call
sign.
•Thecallsignofthecalledrepeateriswrong. •Correctlysetthecalledrepeatercallsign.
Even holding down , the
DR mode will not appear.
•Therepeaterlisthasbeencleared. •ReprogramtherepeaterlistusingtheCS-31clon-
ing software.
•Reprogramtherepeaterlistwiththetransceiver.
Even holding down , the
received call sign will not
set to the operating call
sign
•Thecallsignhasnotbeencorrectlyreceived. •Tryitagain,afterthetransceiverhasagainreceived
its call sign.
The repeater does not ac-
cept your gateway call.
•
Your call sign has not been registered to the D-
STAR system
• Ask your desired repeater’s administrator about call
sign registration.
• While operating D-STAR